One possibility... connect a global VCC power symbol to your "something else" symbol. BUT... Make sure there are no other nets called "VCC" that cannot be connected to the "something else" Ed Caldwell PCB Designer USA 678-473-8707 mailto:ed.caldwell@xxxxxxxxxx EDS http://www.eds-pcb.com sjchar3@xxxxxxxxxxxx Sent by: icu-pcb-forum-bounce@xxxxxxxxxxxxx 01/17/2007 03:30 PM Please respond to icu-pcb-forum@xxxxxxxxxxxxx To icu-pcb-forum@xxxxxxxxxxxxx cc Subject [PCB_FORUM] change net to vcc pin Group Never had to do this but, I used the nand gate from orcad library. The power and gnd pins are hidden and are hooked to VCC and Gnd. I would like to change VCC net to something else, can i do this without building another part? Thanks Sam Check Out the new free AIM(R) Mail -- 2 GB of storage and industry-leading spam and email virus protection.