Hi George, I loaded 15.7, and don't see it any different than in 15.2. Unless I missed something...but the spreadsheet only allows me to use "Electrical Constraint Sets", not any of the "Constraint Sets" that are setup in "Physical(Lines/Vias) Rule Set" "Set values...". Best Regards, Austin > -----Original Message----- > From: icu-pcb-forum-bounce@xxxxxxxxxxxxx > [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx]On Behalf Of > george.h.patrick@xxxxxxxxxxxxx > Sent: Wednesday, March 26, 2008 1:06 PM > To: icu-pcb-forum@xxxxxxxxxxxxx > Subject: [PCB_FORUM] Re: Using an "Electrical CSET" vs a "Constraint > Set" for diff pairs... > > > > This was addressed in 15.5 (if I remember correctly) > > -- > George Patrick > Tektronix, Inc. > Central Engineering, EDS Applications Support > P.O. Box 500, M/S 39-512 > Beaverton, OR 97077-0001 > * 503-627-5272 (voice) * 503-627-5587 (fax) > http://www.tektronix.com http://www.pcb-designer.com > > "Off-Grid and Proud of it!" > > > -----Original Message----- > From: icu-pcb-forum-bounce@xxxxxxxxxxxxx > [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Austin Franklin > Sent: Wednesday, March 26, 2008 11:39 > To: icu-pcb-forum@xxxxxxxxxxxxx > Subject: [PCB_FORUM] Using an "Electrical CSET" vs a "Constraint Set" > for diff pairs... > > > Hi, > > There appear to be two ways to get the diff pair spacing and gap, but > only > one allows differing them by layer. Setting up an "Electrical CSET" > only > seems to allow one overall (as in for all layers) space/gap. But, the > advantage of using the ECSET is you can assign it to a net or multiple > nets > using the Constraints Manager spreadsheet using a pulldown menu. > > Or, I can setup a "Constraint Set" and select each layer's > space/gap...but I > then have to attach this as a property to each and every net manually by > selecting the nets and attaching this Constraint Set name as a > NET_PHYSICAL_TYPE attribute. > > I prefer the Constraint Set, since it gives me the per layer > control...but > the thing that seems to be missing, is the ability to assign a given > Constraint Set to the nets using the Constraint Manager spreadsheet. > > I'm on 15.2. Am I missing something? If not, has this improved on 15.7 > or > 16? > > Regards, > > Austin > > ----------------------------------------------------------- > To subscribe/unsubscribe: > Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx > with a subject of subscribe or unsubscribe > > To view the archives of this list go to > //www.freelists.org/archives/icu-pcb-forum/ > > Problems or Questions: > Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx > ----------------------------------------------------------- > > ----------------------------------------------------------- > To subscribe/unsubscribe: > Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx > with a subject of subscribe or unsubscribe > > To view the archives of this list go to > //www.freelists.org/archives/icu-pcb-forum/ > > Problems or Questions: > Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx > ----------------------------------------------------------- ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------