A reload did the trick, Thanks. -----Original Message----- From: Oscar Migs <o.miguelino@xxxxxxxxx> To: icu-pcb-forum <icu-pcb-forum@xxxxxxxxxxxxx> Sent: Tue, Apr 10, 2012 11:28 am Subject: [PCB_FORUM] Re: Can't remember anything. Yes, but make sure that IT gives you admin rights to your machine. -oscar On Tue, Apr 10, 2012 at 11:16 AM, <sjchar3@xxxxxxxxxxxx> wrote: Thanks Oscar, would that mean reloading cadence? -----Original Message----- From: Oscar Migs <o.miguelino@xxxxxxxxx> To: icu-pcb-forum <icu-pcb-forum@xxxxxxxxxxxxx> Sent: Tue, Apr 10, 2012 10:00 am Subject: [PCB_FORUM] Re: Can't remember anything. It sounds like a firewall problem. Did IT disable UAC before installing Cadence? Best regards, -oscar On Mon, Apr 9, 2012 at 12:29 PM, <sjchar3@xxxxxxxxxxxx> wrote: Group, IT Loaded Cadence on a laptop (win7) and Orcad and Allegro (16.3) both work. I opened the schematic and ran update netlist and checked box to "Create or Update PCB" and "Open Board in Allegro PCB editor", but nothing is happening. Normally Allegro would pop up with updated board. Been awhile but is there something I'm missing, why doesn't Allegro automatically pop up? I also did the setup in Create Netlist, but that path keeps disappearing. Thanks for any input. Sam.