Hi Don, Where can i get the version 3 of the Gps? Do i go to Cindero and buy it or something. I like my current version and must decide whether to move forward on this. Hope you guys are having a great summer. Bob and arlo ----- Original Message ----- From: "Don Bishop" <w6smb@xxxxxxxxxxxxx> To: <gps-talkusers@xxxxxxxxxxxxx> Sent: Saturday, July 17, 2004 10:20 PM Subject: [gps-talkusers] Re: Challenge Loading V3 Upgrade > Hi, > > Not sure if these were typing errors or actual descriptions of what you did, but hopefully this will give you some clues. > > You say you moved the v3 exe file to the root of the bn drive. Do you mean the flash disk? I can't recall the exact file name of the .exe file off the top of my > head, but it's the one on the one cd which isn't in a pocket of the book o cd's constituting the gps maps. > > You later say you pressed a for applications and went to the compact flash card. If you actually did copy the v3.exe file to your root of the flash disk, you > should actually have gone there instead of to the flash card. > > Finally, from your description, it almost sounds like you actually tried to run another file rather than the v3 timed exe. > > > > I hope this can help you out. > > Don > > On Sat, 17 Jul 2004 21:47:25 -0700, Rich Irwin wrote: > > Can someone help me out. I have followed what I understand to be the > instructions to install the V3 upgrade and continually run into the same > obstacle no matter how I approach the installation. > 1. I have replaced all maps, poi's, and doc's with those from the new CD's. > 2. I have copied the v3.exe file to the root of the cf drive. > 3. I have done a reset with "fds" and waited until the BN announced "main > menu". Contrary to the instructions in the v3 readme, there was only one > set of chimes, not two. > 4. I then pressed "u" for utilities. > 5. I then pressed "a" and it said "run program from what drive?" > 6. I pressed "c" for compact flash. It then responded with "directory name? > Press enter for /." > 7. I pressed "enter". It responded with "program name? Press enter for > braillenotetimed.exe". > 8. I pressed "enter" and it responded with "command line?" > 9. Again, I pressed "enter" It responded with "Welcome to . . . Press enter > to start installation or esc to cancel. > 10. I pressed "enter" and it almost immediately responds with "gpstalk.dll > The process cannot access the file because it is being used by another > process. Could not not install gpstalk.dll The process cannot access the > file because it is being used by another process. To exit press enter." > > Where do I go from here? How do I get past this message or what am I doing > wrong? > Rich Irwin > rich.irwin@xxxxxxxxxxx > > > > > > >