Have you tried to remove the exchange server from the backup job and repackage it. Then go back into the job and add the server and repackage? With Arcserve I've solved problems with recognizing servers before this way. -----Original Message----- From: Chris McNally [mailto:cmcnally@xxxxxxxxxxxxxxxxxxx] Sent: Thursday, February 06, 2003 1:02 PM To: [ExchangeList] Subject: [exchangelist] ArcServer 2000 and Second Exchange 2000 Server http://www.MSExchange.org/ Hi all, I moved off of my original Exchange box to a new server. The move has gone relatively well but I can't get Arcserve to recognize brick level or message store on the new Exchange server, it only sees the mailboxes that are left on the original server. I have done every combination I can think of for installation of client licenses etc. but I just can't get the new Exchange box to drill down for backups. When I drill down within Arcserve no matter which way I approach the listings under mailboxes are the half dozen or so left on the original server. Any ideas? ------------------------------------------------------ List Archives: http://www.webelists.com/cgi/lyris.pl?enter=exchangelist Exchange Newsletters: http://www.msexchange.org/pages/newsletter.asp Exchange FAQ: http://www.msexchange.org/pages/larticle.asp?type=FAQ ------------------------------------------------------ ISA Server Resource Site: http://www.isaserver.org Windows Security Resource Site: http://www.windowsecurity.com/ Windows 2000/NT Fax Solutions: http://www.ntfaxfaq.com ------------------------------------------------------ You are currently subscribed to this MSExchange.org Discussion List as: kim.vandegrift@xxxxxxxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub')