That is a really clean set up Chris. Very nice. JC On Sun, Mar 13, 2011 at 9:38 PM, Chris Lindh <chris@xxxxxxxxxxxxxxxxx>wrote: > I think you could still use your 7mm set made for an HEI ignition, > you'll just need a wire for the coil to the distributor. You can buy > single wires. I used MSD cut to fit wires on my 406. I cut them a > little long so I could remove the distributor cap with the wires > attached if needed; in hindsight I would have cut them shorter. > > Plug wire looms are critical; burned wires can ruin race day. I have > the same AFR 195 heads as you, and I used Moroso looms made for > centerbolt heads, since the AFR heads have the loom bolt holes on the > sides, between the exhaust ports. I had to grind my header flanges > for clearance. Mounting the looms on the side of the heads means you > can remove the valve covers without disturbing the plug wires. I > found a photo of an engine with the looms I have, I can take a photo > of my wire setup if you want: > > http://sphotos.ak.fbcdn.net/hphotos-ak-snc4/hs072.snc4/34946_10150241742125495_866360494_15003088_1610904_n.jpg > > > On Sun, Mar 13, 2011 at 9:59 PM, Ray Buck <rbuck@xxxxxxxxxxxx> wrote: > > That's a good question. I had a set I was gonna use (I can't remember > what > > brand, but they're 7mm solid core) but they're for an HEI and I have a > > "divorced coil" (well, maybe they're just estranged) setup with the MSD > > distributor. Whattya got in mind? > > > > r > > > > > > On 3/13/2011 7:07 PM, Chris Lindh wrote: > > > > Looks great, making real progress. What plug wires will you run? > > > > > Rules: Please play nicely with others. > > -List members page (text & pic links): > http://www.myelcamino.net/eclist.htm > -List members page (all pics): > http://www.myelcamino.net/ec_list.htm > >