Hi, We are trying to create a document that has some blank lines in it. Our final product should look like: Line 1 Line 2 If we leave a blank line in the word file, this is removed when opened in DBT. If we imbed a line break in the word file like so: Line 1 [[*<*]] Line 2 We get two blank lines instead of one (after removing the para. style). Is there a way to get a single blank line in the final product? On a second front, while I was embedding codes into the word file, I attempted to import an error using this ability. By using: Line1 [[*breakme*]] Line2 I was able import the invalid code into DBT. However, this did not affect embossing at all (this is good!). I see that in the manual you mention the [idle] code, is it possible to insert any code, and have anything not recognized be ignored? Thank you very much! +-------------------------------------------+ | Michael Surato | | Resource Center for Persons | | with Disabilities | | Michigan State University | | 120 Bessey Hall | | East Lansing, MI 48824 | | Voice: (517) 353-9643 Fax: (517) 432-3191 | +-------------------------------------------+ * * * * This message is via list duxhelp at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxhelp-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *