[ddots-l] Re: Auxiliary sends & track outputs
- From: "Luis Elorza" <luiselorza@xxxxxxxxx>
- To: <ddots-l@xxxxxxxxxxxxx>
- Date: Mon, 2 Apr 2007 13:23:48 -0700
i don't think the send output will affect your track output in any way .
----- Original Message -----
From: "Phil Halton" <philhalt@xxxxxxxxxxx>
To: "ddots-l" <ddots-l@xxxxxxxxxxxxx>
Sent: Monday, April 02, 2007 8:44 AM
Subject: [ddots-l] Auxiliary sends & track outputs
I've been reading the CT tutorial on Aux sends & track outputs, and have a
very basic question that's been bugging me ever since I started getting
into MIDI & digital audio.
Here goes...
When you enable a send on a track and adjust the send level, are you in
effect, diverting a portion of the overall level of the track to that
send?
For example, with a reverb buss, if you set the send level at some low
value like -20db, are you sending a small portion of the track s audio to
the reverb buss, and the remaining audio goes out the output assignment?
Is it split off like that? In percentages, say sending 20% to the buss,
and the remaining 80% goes through the output assignment (usually the
Master buss)?
So, if the reverb plugin was set to wet/dry mix of 100%, you would control
the wet/dry mix of the track by sending more or less of the track audio to
the reverb buss (wet portion) with the remaining signal going to the
master buss(dry portion)?
And, I assume that a send level of 0db would send all the track audio to
the buss, with none left to go to the master output field assignment?
** To leave the list, click on the immediately-following link:-
** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe]
** If this link doesn't work then send a message to:
** ddots-l-request@xxxxxxxxxxxxx
** and in the Subject line type
** unsubscribe
** For other list commands such as vacation mode, click on the
** immediately-following link:-
** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq]
** or send a message, to ** ddots-l-request@xxxxxxxxxxxxx with the
Subject:- faq
** To leave the list, click on the immediately-following link:-
** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe]
** If this link doesn't work then send a message to:
** ddots-l-request@xxxxxxxxxxxxx
** and in the Subject line type
** unsubscribe
** For other list commands such as vacation mode, click on the
** immediately-following link:-
** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq]
** or send a message, to
** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq
Other related posts:
