No, the signal that is going to the aux send is completely separate from the signal going to the master bus, just as it would be on a normal mixing console. You do want to have the reverb set to 100% wet so that only reverb is returned to the aux bus.
Gord----- Original Message ----- From: "Phil Halton" <philhalt@xxxxxxxxxxx>
To: "ddots-l" <ddots-l@xxxxxxxxxxxxx> Sent: Monday, April 02, 2007 11:44 AM Subject: [ddots-l] Auxiliary sends & track outputs
I've been reading the CT tutorial on Aux sends & track outputs, and have a very basic question that's been bugging me ever since I started getting into MIDI & digital audio.Here goes...When you enable a send on a track and adjust the send level, are you in effect, diverting a portion of the overall level of the track to that send?For example, with a reverb buss, if you set the send level at some low value like -20db, are you sending a small portion of the track s audio to the reverb buss, and the remaining audio goes out the output assignment? Is it split off like that? In percentages, say sending 20% to the buss, and the remaining 80% goes through the output assignment (usually the Master buss)?So, if the reverb plugin was set to wet/dry mix of 100%, you would control the wet/dry mix of the track by sending more or less of the track audio to the reverb buss (wet portion) with the remaining signal going to the master buss(dry portion)?And, I assume that a send level of 0db would send all the track audio to the buss, with none left to go to the master output field assignment?** To leave the list, click on the immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** ddots-l-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq]** or send a message, to ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq
** To leave the list, click on the immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** ddots-l-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq]** or send a message, to ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq