[bookport] Re: new member
- From: "Robert Acosta" <boacosta@xxxxxxxxxxx>
- To: <bookport@xxxxxxxxxxxxx>
- Date: Sat, 2 Oct 2004 08:38:41 -0700
Congratulations Sharon. The Book Port is fabulous and so is this list.
----- Original Message -----
From: "Sharon Hamm" <shotzy13@xxxxxxxxxxxxx>
To: <bookport@xxxxxxxxxxxxx>
Sent: Friday, October 01, 2004 3:08 PM
Subject: [bookport] new member
> Hello. I just joined the list and am getting a BookPort sometime next
week.
> It was order today. Just wanted to let everyone know of a new member.
> Sharon
> ----- Original Message -----
> From: "Clarence Whaley" <clarence@xxxxxxxxxxx>
> To: <bookport@xxxxxxxxxxxxx>
> Sent: Friday, October 01, 2004 1:49 PM
> Subject: [bookport] Re: Problems with Book Port
>
>
> > I would guess you have a bad cable if wiggling it makes it work.
> >
> >
> >
> > At 12:45 PM 10/1/2004 -0600, you wrote:
> > >Hi. I am having similar problems to a recent topic of discussion on
this
> > >list--book port not being recognized after firmware and software
updates
> > >were installed. I am using Windows XP service pack two and am
wondering
> if
> > >this is causing this problem.
> > >
> > >When I connect the book port to the usb cable nothing happens. The
> software
> > >does not launch unless I fiddle or jiggle the cable end closest to the
> book
> > >port and then I can get the book port transfer to launch. After I
> > >disconnect the book port it some times locks up and no amount of
presses
> of
> > >the two and the b keys reset the unit. I had to remove the batteries
> > >yesterday in order to get the unit going again. I even pressed the d e
> and
> > >f keys so as not to lose my settings and lost them anyway. Anybody
else
> had
> > >this problem?
> > >
> > >Michael Massey
> >
> >
> > Clarence Whaley
> > Training Division Manager
> > GW Micro
> > E-Mail: Clarence@xxxxxxxxxxx
> > Direct Voice (615) 383-6248
> > or 866-699-8901
> > Direct Fax (260) 489-2608
> > GW Micro Voice Number 260-489-3671
> > http://www.gwmicro.com
> > or press enter below to read all about our training program
> > http://www.gwmicro.com/training
> >
> >
> >
>
>
>
Other related posts:
