[blindwoodworker] Re: Studs again
- From: "Frank Loverme" <floverme@xxxxxxxxxxxxxxx>
- To: <blindwoodworker@xxxxxxxxxxxxx>
- Date: Wed, 15 Feb 2012 19:15:15 -0500
The drill bit is about 6 inches and I have had the 3 inch screws, but have yet
to use the jig. Hell, I am still looking
for the alan wrench to tighten the shifting mechhanism, for my new skill table
saw.
I'm Always, Frank
----- Original Message -----
From: "John Sherrer" <john@xxxxxxxxxxxxx>
To: <blindwoodworker@xxxxxxxxxxxxx>
Sent: Wednesday, February 15, 2012 1:48 PM
Subject: [blindwoodworker] Re: Studs again
3 inch screws are available for the Kreg jig.
John
-----Original Message-----
From: blindwoodworker-bounce@xxxxxxxxxxxxx
[mailto:blindwoodworker-bounce@xxxxxxxxxxxxx] On Behalf Of Dan Rossi
Sent: Wednesday, February 15, 2012 9:44 AM
To: blindwoodworker@xxxxxxxxxxxxx
Subject: [blindwoodworker] Re: Studs again
I think you can use the Kreg jig on your 2X2 if you so desire. It's just
that, with it's 15 degree preset, you will probably not get a heavy enough
screw, or long enough in there.
I don't know off the top of my head, but what is the recommended screw
length for the Kreg jig going from a 2X into a 2X?
--
Blue skies.
Dan Rossi
Carnegie Mellon University.
E-Mail: dr25@xxxxxxxxxxxxxx
Tel: (412) 268-9081
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.455 / Virus Database: 271.1.1/4210 - Release Date: 02/14/12
19:34:00
Other related posts:
