[amayausers] Re: needles and thread breaks on nylon jacket
- From: "Avalon Embroidery" <avalonembroidery@xxxxxxx>
- To: <amayausers@xxxxxxxxxxxxx>
- Date: Thu, 15 Dec 2005 11:09:26 -0800
Re: [amayausers] Re: needles and thread breaks on nylon jacketscientific
testing is now showing the FONT to be part of the problem.
using CooperDak .4" letters sewing out RHS letters........all is well
through 6 sewouts on the nylon.
using Full Block .4" letters sewing out RHS.......the needle just busted
on the H. All 4 needle breaks have been when using Full Block only.
I'm starting to suspect a problem in density in the lettering of this font.
----- Original Message -----
From: Roland R. Irish III
To: amayausers@xxxxxxxxxxxxx
Sent: Thursday, December 15, 2005 11:11 AM
Subject: [amayausers] Re: needles and thread breaks on nylon jacket
When we get the 'shredding' we run a fingernail done the needle in
question-and if there is a 'burr' you'll feel your finger tip catch on it...and
that means your needle is hitting on something-either off center and hitting
the needle plate, or your jacket is hanging off the table and pulled the hoop
as the needle went through-and the needle hit the plate. Or someone
repositioned the jacket as it was sewing or (I've done this) accidentally hit
the hoop arm bending over to get something...
doesn't take much at all to make that needle go sidewise, just a hair and it
will hit the plate underneath and cause a 'burr' when the tip bends a little.
That's what catches and unravels the thread but it keeps on sewing....
Roland
From: "Avalon Embroidery" <avalonembroidery@xxxxxxx>
Reply-To: amayausers@xxxxxxxxxxxxx
Date: Thu, 15 Dec 2005 10:43:09 -0800
To: <amayausers@xxxxxxxxxxxxx>
Subject: [amayausers] Re: needles and thread breaks on nylon jacket
Judy
I'm getting "partial" shredding breaks......where it appears the inner core
of the thread usually stays intact, but the outer "shell" gets all knotted up
in the needle case area...
----- Original Message -----
From: OnleeJudy@xxxxxxx
To: amayausers@xxxxxxxxxxxxx
Sent: Thursday, December 15, 2005 10:31 AM
Subject: [amayausers] Re: needles and thread breaks on nylon jacket
Hi there. A couple of things to try...more backing, as nylon is very
light, and sew slow....and depending on the type of thread breaks (clean breaks
or shredding breaks), check needle alignment, and add or subtract MT.
BEST WISHES!
Other related posts:
