[amayausers.com] Re: X Motor Error using XT WACF
- From: theboards@xxxxxxxxxxxxxx
- To: amayausers@xxxxxxxxxxxxx
- Date: Sat, 30 May 2009 22:48:59 UT
This message was posted by Amy on AmayaUsers.com. PLEASE DO NOT REPLY VIA
EMAIL. Instead, respond to the thread on the WEBSITE by clicking here:
http://www.amayausers.com/boards/ultimatebb.php?/topic/1/699.html#000002
I already tried moving it closer to the center. Now it is no where near of the
hoop on the monitor. I still get the clunk when I do the trace. It moves
counter clockwise and then "clunk" and I get the X motor error.
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
Other related posts: