Same thing happening to me on about 50% of the time. Different needles/colors and on different designs. Could it be the trimmer blades need servicing/replacement? Steve -----Original Message----- From: amayausers-bounce@xxxxxxxxxxxxx [mailto:amayausers-bounce@xxxxxxxxxxxxx] On Behalf Of webmaster@xxxxxxxxxxxxxx Sent: Thursday, January 24, 2008 8:33 PM To: amayausers@xxxxxxxxxxxxx Subject: [amayausers.com] Re: Thread break after every trim This message was posted by LibertyGroup on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/1/318.html Please bear with me, I'm a newbie. I have the XT and it's been working fine until today. I am sewing out a design that I have done dozens of times but today, it seems after every trim I'm getting a thread break. I have gotten through a few designs and noticed the bobbin isn't being cut at the end. I don't think the bobbin is being cut when a trim occurs either. This is probably the issue but I have no idea how to fix it. Any ideas? =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list =========================================================== =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================