The bulk of the sewing was done with magnetic bobbins-simple to try
them. I had set the bobbins for regular open bobbins-so that the
bobbin stays in place until you 'jiggle' it a little-then it would
slowly unroll a couple inches and gradually stop. Didn't change it
for the magnetic ones but sometimes we loosen it up for them.
Also make sure every time we change a bobbin we clean under the
tension bar and inside-there are some recesses that load up with crap
there. I have 3 bobbin holders so it is easy to have them setup ahead
of time to keep moving.
If we get the hat attachment back on today for this small order I'll
keep an eye on it and see what the auto tension does.
Roland
Roland, Describe your bobbin tension for us. Herb