> Hi Fredrik > > On Wednesday 17 May 2006 07:53, Fredrik Wikstrom wrote: >> I'm using the latest E-UAE-0.8.29-WIP2 SDL version for AmigaOS4. In the >> .uaerc file I have the following lines: >> >> # enable all floppys (0=on, -1=off) >> floppy0=0 >> floppy1=0 >> floppy2=0 >> floppy3=0 >> >> When I run E-UAE only drives DF0: and DF1: are working... E-UAE doesn't >> complain about unknown config entries however so I would assume that >> means it recognises them, but the drives DF2: and DF3: still act as >> though they were disabled. > > Also set nr_floppies=4. > Hi again, Just found out what I was doing wrong. The floppy<number>type is the setting to use for enabling/disabling diskdrives (not floppy<number>). No wonder it wasn't working... Regards, Fredrik Wikstrom