I don't have that manual but maybe the info from a CT27G12 will help. It uses a LA7837 chip, pin 8 is VCC2, 26 volts from pin 8 of the flyback fused by R552 and rectified by D561. C551 is the filter. R552 is 1 ohm. Pin 1 of the LA7837 is VCC1 and should have 9 volts. HTH Jim Myers, DGT Since 1972 Telrad Electronic Services Co. Fort Wayne, IN 46815 jr.myers@xxxxxxxxxxx 260-432-4486 Fax and Voice Fax is always on ----- Original Message ----- From: "andy's tv & vcr service" <atv@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, October 29, 2002 9:38 PM Subject: [TechAssist] panasonic ct-27g11u no vertical Hello Everyone Have this panasonic tv with no vert sweep, this tv started out with bad solder connections and the customer's son tried to repair him self. now i have it. i replaced the ic ers the filters and don't have the b+ to the ic would someone have the location # and valu of resistor. thank you any help and your time. Andy atv@xxxxxxx Andy's TV & VCR Service 724-379-8559 voice/ fax Donora, Pa. ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/