Well, two ten mfd's in line may be OK for testing, but they get hot and a bit narrow still. But it confirmed my fix. Location CH14, 4.7 mfd BP @50V cured it (yoke return cap) . I located one in a Zenith module. Zenith 9-1335 boards use them at location CX3288 behind the vert output IC. Installed the Zenith cap and full width and cap runs cool. Phil Phil Bader wrote: > Picture was only about 2 inches wide . (vertical was OK) I located a > bulged capacitor CH14 (4.7 mfd@50V, 85 deg) connected to one > deflection yoke pin. Looks like it is Bi-Polor. > Probably will be the fix. > Can I use two standard 10 mfd's "back to back (+--+) or is a carnal sin > among technicians? Will it hold if higher working voltage ratings used? > I doubt if I will lay my hands on a 4.7 mdf bi-polor@ 50V easily or cost > effectively. > > Phil > > -- > > Philip Bader > Jan Phyl TV Inc. (estab. 1976) > 3420 Recker Hwy. Winter Haven, Fl. 33880 > Fax (863) 299-8821 > email: tjanphyl@xxxxxxxxxxxxxxx > > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ -- Philip Bader Jan Phyl TV Inc. (estab. 1976) 3420 Recker Hwy. Winter Haven, Fl. 33880 Fax (863) 299-8821 email: tjanphyl@xxxxxxxxxxxxxxx ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/