Where do I get an isolation transformer to isolate CRT from power supply Thanks, Dale Dale A. Lubow... HarrisTV50010@xxxxxxx ..515-232-1109..(Fax)515-232-3356 Harris TV & Appliance..........335 Lincoln Way.....Ames.....Iowa.....50010-3384 In a message dated 3/8/02 9:26:42 PM Central Standard Time, videoclinicpana@xxxxxxxxx writes: > dont for get to add an isolation transformer in the filament circuit to > isolate the pix tube from the power supply.. ive had very good luck with > this. > > roy aka videoclinicpana@xxxxxxxxx > > ----- Original Message ----- > From: "Jeff Dougherty" <jeff@xxxxxxxxxxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Friday, March 08, 2002 6:38 PM > Subject: [TechAssist] Re: Zenith Z32X31D(GX Chassis) w/9-01812 Module has > bad QX3401 > > > > > > Dale, > > Replace the cap next to the regulator, AND the regulator. > > Also advise the customer, these parts may have failed due to an > intermittent > > short in the picture tube, your repair may last a week or several months. > > Jeff > > > > FAX 717-564-4952 > > Jeff Dougherty > > Intrepid Video & Electronics > > 501 Luther Rd > > Harrisburg, PA 17111 > > 717-909-8844 > > VCR tips, electronics info & general interest. > > www.intrepid-video.com www.tech-repair.net www.thetoolcaddy.com > > > > > > ----- Original Message ----- > > From: <HarrisTV50010@xxxxxxx> > > To: <techassist@xxxxxxxxxxxxx> > > Sent: Friday, March 08, 2002 10:38 AM > > Subject: [TechAssist] Zenith Z32X31D(GX Chassis) w/9-01812 Module has bad > > QX3401 > > > > > > > > > > We are working on a Zenith Model# Z32X31D, GX Chassis, Main Module # > > 9-01812 > > > > > > It has a Shorted QX3401, open RX3404, RX3406 & FX3401. > ICX3431(STR53041) > > > seems to be OK when checked with an ohm meter. Does any one have any > ideas > > > what might have caused this and are there any other parts that normally > go > > > bad? > > > > > > Thanks, > > > Dale > > > > > > Dale A. Lubow... HarrisTV50010@xxxxxxx > ..515-232-1109..(Fax)515-232-3356 > ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.