This set will stay on chan. 2, if you change chan. it shows on OSD the chan. number changing but it always stays on chan. 2. I auto programmed the set, it shows that the active chan. were found, but it still stays on chan. 2. I cant check the 33v line because i don't have a print. I remember reading somewhere that there was a .01mf from one of the tuner pins to ground shorted and causing a problem like that. any help will be a big help. Thanks, Mark Thank you, Electronic Repair Services 48 W. James St. Lancaster, PA 17603 ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html