I had a oddball on one of these that drove me nuts. Turned out the mirror mount in one corner had let go. Mirror was hanging loose in one corner. Also, there is a mod for a small three component IC on the convergence panel. I can't remember off hand. An of you guys out there remember ? Keith Trumbla Winnipeg, MB Canada Phone. 204-832-6237 ----- Original Message ----- From: "Larry E" <videotech@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, April 06, 2005 2:01 PM Subject: [TechAssist] Zenith IQB50M90W converg prob. Hitachi Guts?? > Hi Guys, went out on this IQB50M90W, ZP90 chassis for a complaint of poor > convergence and it has Hitachi boards in it, all green led`s are lit, red protect led > is not blinking, replaced both STK`s, made no difference, I must be missing a voltage > to the IC`s but I`ve never seen this set-up before so I`m going to need a little > help, any ideas ? tia, Larry E > Larry Eastman > American TV & Electronics > Crystal River, Fl. 34428 > > -------------------------------------------------------------------------- --- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ > > ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/