Kevin, Check and see if you have any standby voltages... +15 at D3411 and +5 at ZDX3401.... +124 at LX3405.. use tuner ground... ICX3431 {223-28} pins 1 -41.7V 2 .34V 3 155V 4 .11 measurements from negative side of CX3405 ..if there ok remove and check RX3404 180K ... Replace Cx3413 22/50 and Cx3416 100/25>>to 63V.. Have not seen any bad picture tubes.... Bob, Bobs TV Worcester, ma woodman1@xxxxxxxx Main 508-853-1482 Fax 508-853-1480 ----- Original Message ----- From: "Kevin" <kevintv@xxxxxxx> To: "TECH-ASSIST" <techassist@xxxxxxxxxxxxx> Sent: Tuesday, February 11, 2003 4:52 AM Subject: [TechAssist] Zenith GA-3 chassis, dead > Hi fellow techs, > > I am not familiar with this Zenith GA-3 chassis. The set is dead and I > don’t have the schematic. I haven’t found any shorted transistors or > diodes. Are these the sets that had a history of bad picture tubes? It > was manufactured in August 1998. Any help would be appreciated. TIA > > Kevin Wilks > Kevin's TV & Video Repair > Penticton BC Canada > kevintv@xxxxxxx > > > **************************************************************************** * > Submit A Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.html > **************************************************************************** * > For automatic password retrieval 24 hours a day, go to: > http://www.tech-assist.org and select "Lost your Login Info?". > **************************************************************************** * ***************************************************************************** Submit A Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.html ***************************************************************************** For automatic password retrieval 24 hours a day, go to: http://www.tech-assist.org and select "Lost your Login Info?". *****************************************************************************