Evidently you can not go by looking in these CRT's. Even though the video looked bowed and short at one end, when I took light box back to customer's home I had a good picture and only minor geometry and convergence adjustments were needed. Thanks to all that responded. Jeff -- Intrepid Video TV/VCR Repair 263 S Front St, Steelton PA 17113 717-939-7708; (F) 717-564-4952 www.intrepid-video.com www.tech-repair.net ----- Original Message ----- From: "Intrepid Video Support" <support@xxxxxxxxxxxxxxxxxx> To: "Techassist" <techassist@xxxxxxxxxxxxx> Sent: Wednesday, September 22, 2004 11:38 AM Subject: [TechAssist] Zenith, 9-1674, 9-1690 wiring Z52Z95DB Good day... Its been a while since I did one of these.. I replaced the 9-1690 and had to transfer the connectors as the originals were soldered onto the 9-1690. I'm pretty sure I looked at these before I removed them and the black wire was lined up with pin one of the connector indicated by a small dot. On the 9-1849 and 9-1674, the black wire is at the opposite end of the pin indication. Can someone email me the schematic or wiring diagram for this set? I'd really appreciate it..I replaced the 9-1690 with one I have had here for some time and the convergence was still out and severely bowed, so I ordered a new one, but want to double check this before I install it. Thank you. Jeff -- Intrepid Video TV/VCR Repair 263 S Front St, Steelton PA 17113 717-939-7708; (F) 717-564-4952 www.intrepid-video.com www.tech-repair.net ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/