Phil, Actually I found 2 more things to check on this one. If the horz sync pulse is missing on pin 21 of IC6000: Check for shorted diode CR2250 (103-471A). This will ground out the pulse necessary for micro-p to know where to put the OSD. If the horz sync pulse is OK at pin 21 of IC6000, and the Vert sync pulse is OK at pin 22 of IC6000, and the data lines from IC6000 to the signal proc IC1200 show NO activity, then replace the micro-p IC6000 (221-685). HTH LLW LeRoy Westlund Westlund TV & Electronics " I've enjoyed 93 North Main as much of this, Centerfield, UT 84622-0087 as I can stand " Ph./Fax 435-528-3822 mailto:LLW@xxxxxxxxxx -----Original Message----- From: Phil Bader <philbad@xxxxxxxxxx> To: techassist@xxxxxxxxxxxxx <techassist@xxxxxxxxxxxxx> Date: Monday, May 20, 2002 6:07 PM Subject: [TechAssist] Zenith 20" TV,SJ7935W, 9-1118 main no OSD > >Zenith SJ7935W, 9-1118 main.This is unusual.The TV will turn on,change >volume and ststions manually and on remote,but no OSD characters at >all.I found three blue caps bad,but same symptom.What generates OSD on >this panel? (uses IC6000 uP: 221-685, video IC1200,221-679, 14 pin >IC6200 near tuner, 221-656)-Phil Bader >-- >Philip Bader, Jan Phyl TV Inc. >3420 Recker Hwy,Winter Haven, Fl. 33880 >voice/fax: 863-299-8821 >Established 1976 >------------------------------------------ >To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html >To CHANGE your email address, click here: > http://www.tech-assist.org/change.html >------------------------------------------ >***NEW*** Tips Added Instantly!!!*** >Submit Repair Tips here: >http://www.tech-assist.org/secure/tip/ > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.tech-assist.org/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/