I replaced R4151M with 1k-1/2w and the new one blew. I come to find QX3404(121-1102) shorted E-C, but I'm not sure if this caused the new resistor to blow, or from another fault somewhere. I am working without a schematic. If anyone has ideas, or can fax portion of prints, I would be appreciative. Thank you. Jeff FAX 717-564-4952 Jeff Dougherty Intrepid Video & Electronics 501 Luther Rd Harrisburg, PA 17111 717-909-8844 VCR tips, electronics info & general interest. www.intrepid-video.com www.tech-repair.net www.thetoolcaddy.com ----- Original Message ----- To: "Techsonline" <techassist@xxxxxxxxxxxxx> Sent: Friday, March 08, 2002 11:57 PM Subject: [TechAssist] Re: **UPD*NEED PART ID**Zenith RZ46Z83D7, no conv adjust and no menu adjustments > > It looks like all my emails are lost for the day, since lunch time anyway. I > had to change my email address for the list, temporarily.(This is where it > helps to have more than one domain) > If anyone replied to me on this, please resend. > Right now the problem I have is the top corner of all three tubes are bowed > downward, then curve back up. > The blue is a lot worse than the other two. > Now, I found R4151M SM resistor on conv board reading at 160k, number on it > is 102-should this be a 1k resistor? Also, would it be proper to use a > regular resistor in it's place, if this one increased in value? > Does anyone have any ideas, if this resistor does not fix this problem, as > to what may cause these pictures to bow, just at the corner? Those two one > ohm resistors still get really hot to touch. > I did find C3460 high ESR and checked the two resistors 110k and 82k. > Thank you. > Jeff > >> [ > > Hello, > > I think I still need help on this. I have light box here right now using > the > > ceiling, but it looks like the convergence is stilled bowed. > > I replaced the two STK392-110, R4162, 4163, 4161 and R1460. R4160 and > R4161 > > gets extremely hot to touch. The convergence looks better, though at the > top > > left corner, all colors are bowing downwards. > > On pins 6-14-15 of STK's I have no, or less than 1vdc on each. Is this > > normal? > > Thanks to all that have helped so far > > > ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.