Just seen a similar one. First of all remove the HV from all 3 tubes, and the focus lead. If it comes on you have a cracked tube and a fried yoke. If it does not work, remove the yokes one by one. Other possible cause is the audio IC. HTH Jorge At 03:25 p.m. 14/07/03 -0700, you wrote: >Repairing this in home. Originally brought in convergence board because it >had the common failure IC's, but could not find anything open or shorted. >Went back installed and pulled main chassis and replaced vertical output >IC and 3 caps that did not check too well. The Ic was slightly darkened. I >can't find anything else but was wondering if I should check anything else >out on this chassis before taking it back and try. The unit would try to >power up in the home and i could here the high voltage try to start. >TIA Neil > >Tv Doctors >Monroe,Wa >***************************************************************************** >CHECK OUT THE NEW CHATROOM! Just login and click on chat! >http://www.tech-assist.org/secure/tip/main.htm >The Tech Address Book: >http://www.tech-assist.org/secure/tip/contact.htm >Add a Repair Tip Here, or Change/Remove your Email Address: >http://www.tech-assist.org/secure/tip/main.htm >Lost Password: >http://www.tech-assist.org and select "Lost your Login Info?". >Email Archives: >//www.freelists.org/archives/techassist/ Jorge Camboni, GY Electronics, Richardson, TX ***************************************************************************** CHECK OUT THE NEW CHATROOM! Just login and click on chat! http://www.tech-assist.org/secure/tip/main.htm The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/