I have the service manual in PDF (that someone else sent to me) or you can access the manual for free at Memorex.com. Use memorex model MVT2135B. The horiz B+ should be +135v. If that is working you should also have the standby sources; always +12 on D512 cathode and power-on +5v out of IC501-pin 2 (input on pin 1 and switching v on 4). Check for always 12v on D512 cathode and see if it drops when you push the power button. If so, change D512 and D514. Let me know if you need the Toshiba manual. John. Philip Bader wrote: > Dead. HOT collector has about +200V on it! There are other standby volts > around.Push power and nothing at all. I pulled chassis to access the I/R > detector diode in front. No where on any pins is voltage. Usually a good > place to find the 5V standby. > So, guess no +5V stby for starters. > There is one regulator IC (TO-220 package like 7805's) IC501: "KIA78 > R05P1" a four pin reg. NO output. Don't know if it's a switched output > or my missing standby. > Help! > Phil Bader -- John Mielke Main TV Longmont,Co 80501 303 776 6955 303 776 0792 fax maintv@xxxxxxxxxxx ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/