I have run into the same problem, but fixed it by breaking off the tabs on the rear side & using a panavise to hold the tuner & set the connector on the tuner & use a hi wattage soldering iron to quickly solder it to the tuner. Use a short heat sync for the center conductor to keep it centered. Maybe someone knows of a better way, but this has worked for me many times. Larry Larrys TV Service Broken Arrow OK 74011 phone 918-455-1041 Fax 918-451-4485 e-mail lpoffen@xxxxxxx ----- Original Message ----- From: "TV Man" <tvman@xxxxxxxxxxxxxxx> To: "TV Tech Line" <techassist@xxxxxxxxxxxxx> Sent: Wednesday, March 10, 2004 10:08 AM Subject: [TechAssist] TV=Tuner connectors > I have the RCA tuner connectors # 215543. But on other brands this is to big[where is gets soldered on to the board].I have a lot of units that the cable pulled the connectors right out but I need a connector that where it gets soldered to the tuner board it's smaller then the 215543. Does anyone know were I can get some? Thanks, Dave > TV Man > Inverness, Fl. > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/