That was a common problem with Magnavox tuners a few years ago where the PLL IC went bad. Does that ring any bells? If the PLL is in the tuner then it's a bad tuner. ************************************************** Jim Myers Since 1972 Telrad Electronic Services Co. Fort Wayne, IN 46815 ************************************************* ----- Original Message ----- From: "Intrepid Video Support" <support@xxxxxxxxxxxxxxxxxx> To: "Techassist" <techassist@xxxxxxxxxxxxx> Sent: Friday, June 13, 2003 4:21 PM Subject: [TechAssist] Sylvania(Funai) 6319CC various intermittent problems Customer says the following: When changing channels, OSD changes, but video stays on channel three(intermittent) Intermittently will not go on with the remote. I have gone over the unit and can not get it to act up. All I can think to do is go over solder connections. Is there any case history for these problems? This is June 2002 model. Thank you. Jeff Dougherty Intrepid Video TV/VCR 263 S Front St Steelton PA 17113 ph..717-939-7708 fax...717-564-4952 www.intrepid-video.com www.tech-repair.net **************************************************************************** * The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.html Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/ ***************************************************************************** The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.html Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/