diode that rectifies the 26vollts from flyback should be a ecg552. Jerry wrote: >D502 is a Sharp part # RH-DX0131CEZZ, I don't know if there is a good >generic cross for this. It is the +26 volt supply for vertical and >regulator control. I would check the vertical output ic as well TA8427K... >Jerry >----- Original Message ----- >From: <Dude1127@xxxxxxx> >To: <techassist@xxxxxxxxxxxxx> >Sent: Tuesday, October 30, 2001 9:26 AM >Subject: [TechAssist] Re: Subj: sharp tv27f-s50 > > >| >| Original mesasage: Date: 10/29/01 1:58:46 PM Eastern Standard Time >| From: atv@xxxxxxx (andrew soltes) >| Sender: techassist-bounce@xxxxxxxxxxxxx >| Reply-to: techassist@xxxxxxxxxxxxx >| To: techassist@xxxxxxxxxxxxx >| >| hello everyone >| would someone have the pt# or sub# for diode location d502 on >this >| sharp tv tv came in dead , fuse blown, output trans shorted and diode >| shorted, diode shorted was loading down flyback, ringer showed flyback >bad >| removed diode and ringer good on flyback >| thanks for any help >| andy >| >| andy's tv vcr ser >| donora,pa atv@xxxxxxx >| ----------------- >| ANDY, d502 is RH-DX0131CEZZ (ECG552), Les >| >| Help make your TechAssist online repair tips >| database better! Submit your fixes here: >| http://www.circuitwork.com/techassist/tip/#tips >| To unsubscribe write to: >| techassist-request@xxxxxxxxxxxxx >| with unsubscribe in the subject line. > > >Help make your TechAssist online repair tips >database better! Submit your fixes here: >http://www.circuitwork.com/techassist/tip/#tips >To unsubscribe write to: >techassist-request@xxxxxxxxxxxxx >with unsubscribe in the subject line. > Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.