The 3VAC is the fillament voltage, you should have between -20 & -30VDC on the rest of the pins with data on them. If you don't have the -voltage check the power supply, if the voltage is there but there's no data, check the driver ic. Gary -- Carson City TV-VCR 2164 E Hwy 50 Carson City, NV 89701 775-887-9089 fax 775 887-1067 > I have this Sony receiver model number TA-AX311 that works perfect except > the glass tube display does not light up. I checked some voltages comming to > the 2 outside pins and it was about 2-3 volt ac so I replaced the display > tube with original Sony part1-519-663-11 and still no display. Does anyone > have a print on this model or can anyone tell me the voltage readings on the > glass display pins. > > Shaun > > Advanced Electronics > 224 West Riverview Ave. > 970-867-3124 > Fort Morgan, CO 80701 > satguy@xxxxxxxxxxxxx > > ***************************************************************************** > Classifieds! Buy or Sell! > http://sell.tech-assist.org > The Tech Address Book: > http://www.tech-assist.org/secure/tip/contact.htm > Add a Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.htm > Lost Password: > http://www.tech-assist.org and select "Lost your Login Info?". > Email Archives: > //www.freelists.org/archives/techassist/ ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/