Hi Bob, the fly is the most common cuase I have found for this symtom,also check/replace the video drive IC on the C board. I found one Crt internally arcing also and this one had damaged the fly which had to be replaced to see the arcing. Good Luck, Barry MacInnes Television Service Clinic W. Lebanon,NH 03784 foxhole@xxxxxxxxx 603-298-7780 ----- Original Message ----- From: "Bob@Bobs tv" <woodman1@xxxxxxxx> To: "TechAsist M" <techassist@xxxxxxxxxxxxx> Sent: Thursday, October 14, 2004 12:33 PM Subject: [TechAssist] Sony KV32FS13 Dead > KV32FS13 > SCC-S40--QA > This set appears to have a over current problem, when the power is turned on set comes on then clicks off with two blinks.. When turning on, the B+ changes so fast you can not read on meter...Monitoring the HV at turn on, the HV does not try to come up. Unhooking HOT the B+ goes to 135V for aprox 5 seconds then shuts down again.. Did a visual check along with static check of semis, but that is as far as I gone.. Would appreciate any help on how to proceed, as this is a new set to me... > Using a KV32FS12 manual... > > Thank You > > Bob, > > Bobs TV Worcester, ma > > woodman1@xxxxxxxx > > Main 508-853-1482 > Fax 508-853-1480 > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/