I repaired this Sony's power supply and Horiz section and after completion I brought the AC up slowly and check for current on the isolation meter as always and everything was fine at full line voltage so I applied signal and within a second or two and the set went into shutdown. Would anyone have a clue if I should start at the power supply or the Horiz section. I did replace the flyback and H.O.T. and went over driver connections along with all solder that looked poor. I don't remember anyone having a similar problem like this with any brand. Any help would be greatly appreciated. Thanks much!!! P.S. The chassis power supply and Horiz are still working but AC has to be interrupted and set will stay on indefinitely with out cable signal. Bill Grabowski Triangle Appliance Kenosha,WI bgrabowski@xxxxxxxxx ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/