If this set uses a A49JLV50X Htrs are pins 6 and 5 in the Sams print. The Sencore book may have a misprint it reads pins 7,8 as htrs as well . G1 and G2 pins appear to be wrong as well . Use an ohm meter to determin which Htr pins are correct. The A49JLB50X in the Sencore setup book looks like it could be used for this tube. Htrs F1 = 5 ..........F2=6........ Red K= 10....... Green K =9....... Blue K= 8........G1= 11.......G2= 3.........CRT type=Video............NegBias = 68v. Set switch F1 to 1 Set switch F2 to 2 Set switch K to 3 Set switch G1 to 4 Set switch G2 to 5.............Charlie Charles Belich Slidewire Electronics 108 S. 1st. Ave KL Hibbing , MN 55746 Mailto:seashell@xxxxxxxxxx Ph: 218-263-7090 ----- Original Message ----- From: "W. Blakey" <wblakey@xxxxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Sunday, January 20, 2002 10:58 AM Subject: [TechAssist] Re: Sony KV-1997 If I remember correctly there should be a description in the manual for the CR70. I don't remember the color codes of the clip leads. I look at the neck board to identify the pins on the CRT and put the proper leads on the proper places. Something comes to mind about the switch positions on the tested but I cannot remember what it is. I do not have this tester but it was at the place I worked up until six years ago. Wilf Blakey/Blakey TV,Kirkland Lake,Ont wblakey@xxxxxxxxxxxxxxxx ----- Original Message ----- From: "Shaun" <ssroark@xxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: January 20, 2002 12:40 AM Subject: [TechAssist] Sony KV-1997 > Hello, I was wondering if anyone knows how to use the u/a adapter on a sencore CR70 for this Sony KV-1997. > > Shaun > > ------------------------------------------ > Make your TechAssist database better! > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. > ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above. ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.