You may need to tweak the AFT coil to get the sound in. For the picture distortion , check/replace C614, 22uf @ 250v Jeff Stielau Shoreline Electronics Repair 125 Beechtree Lane Westbrook,CT 06498 860-399-1861 Voice 860-664-3535 Fax jstielau@xxxxxxxx ----- Original Message ----- From: "Shaun" <ssroark@xxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, January 23, 2002 12:56 AM Subject: [TechAssist] Sony KV-1997 > This set has white noise for sound , but pix is clear but not full horz(pulled in on the right side only) if I turn up the ac picture get full and power suply voltages do go up. Which by the way all voltages are a little low even off the bridge which is supposed to be 157v dc and it is around 141v dc the out put is 126v dc and supposed to be 135v dc. I replaced the voltage regulator and no change. any ideas > Shaun > > ------------------------------------------ > Make your TechAssist database better! > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. > ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.