check all caps near the ic a couple are bad roy aka videoclinicpana@xxxxxxxxx ----- Original Message ----- From: <MYERSVCR@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, March 26, 2002 9:34 PM Subject: [TechAssist] Sharp 27F-S40 vertical problems > > Customer complained of horizontal white line. Replaced IC501 (X1224CE) and > picture > jumped to full screen- almost- Black on bottome 1 inch of screen and vertical > linearity is way off- I have no print and there are no adjustments I can see. > If I remember right on these Sharps you have to jump test points to enter > service mode > Can anyone tell me how to enter the service mode and which codes deal > specifically with vertical height and linearity? TIA Craig > ------------------------------------------ > Make your TechAssist database better! > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. --- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.343 / Virus Database: 190 - Release Date: 3/22/2002 _________________________________________________________ Do You Yahoo!? Get your free @yahoo.com address at http://mail.yahoo.com ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.