Ed, Don't have anything specific for your model, but check caps in power supply, possibly C09(22mfd), had this problem with a VR526 and this cap solved it. Dan Webster Webster's TV Shullsburg, Wi. ----- Original Message ----- From: "teltek3" <teltek3@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, August 01, 2003 3:16 PM Subject: [TechAssist] RCA VCR VR352 > Would someone have a Circuit Diagram for a RCA VCR VR352. I have a problem > with Low voltage on the Loading Motor IC..(BA6209) Only have 2.8 volts on > VCC1 and VCC2 Pin 7 and 8. Should probably have 12V or more. So of course > symptom is "Will not Load". I replaced the IC, on speculation, but same > thing. I need either diagram pf the Power Supply or Loading Motor Supplies. > > TIA. > > -Ed- > Tel-Tek Electronics > Ontario-Canada > teltek3@xxxxxxxxxxxx > > **************************************************************************** * > Classifieds! Buy or Sell! > http://sell.tech-assist.org > The Tech Address Book: > http://www.tech-assist.org/secure/tip/contact.htm > Add a Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.htm > Lost Password: > http://www.tech-assist.org and select "Lost your Login Info?". > Email Archives: > //www.freelists.org/archives/techassist/ > ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/