Hi guys, have a lightbox for a CTC169PA projection set that seems to not be regulating correctly. Raw B+ is 159v, pin 16 of U4101 is 11.5v, Cr4118`s cathode is 14.85v, but cathode of cr4116 is 155v, if I hold down the power button this voltage drops to 80 volts and something in the power supply tics, I`ve replaced, C4102,104,108, Cr4118 & C4145, checked across CR4123 and have 5.6 volts, Regulated B+ was 167v before replacing C4102,104 & 108. My tech notes say this problem is caused by either C4102 or CR4123 is zenering at 8.6v instead of 5.6v. Obviously this isn`t the problem, any ideas ??? tia, Larry E -- Larry Eastman American TV & Electronics Crystal River, Fl. http://www.tvjunkyard.com ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/