This set foes down to a vertical line,(Vertical Circuit) only about 1 inch of deflection. It is definitle a bad solder connection, because as soon as I touch the board, to take measurements, it corrects itself. I know this is a STUPID question, but has anyone run across this, just in case this is a common problem with these 36" sets. Have probed the chassis, used cold spray, but can not seen to isolate it. TIA. -Ed- Ed Gaidies Tel-Tek Electronics Ontario-Canada teltek3@xxxxxxxxxxxx ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html