C503 was the culprit for me a couple of times. And it only needed soldering its by the Vert IC..............GoodLuck Bill Grabowski Triangle Appliance Kenosha,Wi bgrabowski@xxxxxxxxx Tel-Tek Electronics wrote: > This set foes down to a vertical line,(Vertical Circuit) only about 1 inch > of deflection. > It is definitle a bad solder connection, because as soon as I touch the > board, to take measurements, it corrects itself. I know this is a STUPID > question, but has anyone run across this, just in case this is a common > problem with these 36" sets. Have probed the chassis, used cold spray, but > can not seen to isolate it. > > TIA. > > -Ed- > Ed Gaidies > Tel-Tek Electronics > Ontario-Canada > > teltek3@xxxxxxxxxxxx > > ------------------------------------------ > Submit A Repair Tip For Everyone Here: > http://www.tech-assist.org/secure/tip/main.html > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > > ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html