This direct view 38" came in with a very dark and out of focus picture. Focus and screen controls had little effect. I replaced the focus and screen control assembly(tech support says that it is high failure), and no help. I measured the screen and focus voltages with the crt board off the tube and they seemed normal. Tech support was certain of a bad crt. Thomson shipped one and I installed it. Now the set "looks" like it is out of sync. The G2 voltage is running low, and if I try to turn it up, the set will shut down. I can turn it up to the listed voltage with it removed from the tube. Does anyone know how to set the Horizontal frequency? I can get my Chipper Check to work on this set, but can't get in the service mode(value 200) because I can't read anything on the screen. TIA Walter ===== Walter Wood Future Tech Home Center 2786 Hwy. 43 N. Lawrenceburg Tn. 38464 931-829-3337 Fax 931-829-4044 mailto:wwood_38478@xxxxxxxxx __________________________________ Do you Yahoo!? Yahoo! SiteBuilder - Free, easy-to-use web site design software http://sitebuilder.yahoo.com ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/