It could be the horizontal parameter is too far off. If you can get a picture at 90 volt AC, get into the service menu and set it for a floating horizontal bar on parameter 01 (around 15). If parameter 01 (horizontal) or parameter 06 (vertical height) are too far out of range you will have no sync, H or V. It will also cause the HV to be too hi causing the shutdown. It is easier to get into the service menu if you disconect the antenna when the picture is out of sync. You could also replace the eeprom or re-program it if you have the equipment. John John Mielke Main TV 636 Main St Longmont, Co 80501 303 776 6955 303 776 0792 fax www.longmontmaintv.com maintv2004@xxxxxxxxxxx ----- Original Message ----- From: <WWill90634@xxxxxxx> To: <Techassist@xxxxxxxxxxxxx> Sent: Friday, September 16, 2005 4:08 PM Subject: [TechAssist] RCA CTC-175A > Just in CTC175A have horizontal and vertical phase problem, running on > variac at 90 volts. If I go over 90 volts the unit will shut down.Maybe regulation > causing phase problem. We don't have service info on this one. > Any help will be appreciated > > TIA > Will > Soundview Electronics > > > -------------------------------------------------------------------------- --- > This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm > Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/