What about the vertical amplifier? those things don't come on if there is no vertical output. You can disconnect the vertical module suspecting it is bad and nothing changes....until you fix it, then the set starts again. Jorge Camboni GY Electronics, Dallas (also cx8bbh) At 11:17 p.m. 26/06/02 -0400, Larry <schntv@xxxxxxxxxxxx> wrote: > >the tubes just flash off and on every 2 seconds. >un plugged the splitter and yoke but still hear it pulsing >every 2 seconds. >where should I start? >Not familiar with this chassis. >Thank you, >Larry > >-- >Schneider TV & Electronic Inc. >5415 N. Wooster ave. >Dover, Ohio 44622 www.geocities.com/schntv2000/ >330-343-0768 FCC. first class & Extra class K8WLY >------------------------------------------ >To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html >To CHANGE your email address, click here: > http://www.tech-assist.org/change.html >------------------------------------------ >***NEW*** Tips Added Instantly!!!*** >Submit Repair Tips here: >http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.tech-assist.org/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/