Somtimes when you change these flybacks you can pull on the focus/screen voltage line because of the lack of slack. Even if the rubber retainer is still connected to the focus/screen control make sure that the metal connector is connected inside. It may have backed out and is arcing. Jason Moutons Electronics ----- Original Message ----- From: "Shaun" <satguy@xxxxxxxxxxxxx> To: "tech" <techassist@xxxxxxxxxxxxx> Sent: Tuesday, December 06, 2005 3:15 PM Subject: [TechAssist] RCA 52GW947 Chassis PTK195PB Horz tearing > This set came in dead, found the flyback (239111) bad. Replaced it and set > looks good but when there is a horizontal line on the picture it tears all > the way across the picture it looks like arcing from the high voltage > block > when a wire is not pushed in right. All the wires in the high voltage > block > are in tight and correct. Is there any tips for this problem anywhere I > looked in the archives but found nothing for this problem. > > Shaun > > Advanced Electronics > 224 West Riverview Ave. > Fort Morgan, CO 80701 > > ----------------------------------------------------------------------------- > This Email List is accessible to the general public through search > engines. Remove: http://www.tech-assist.org/remove.htm > Set Vacation > mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/