Robert, Just to be more precise, the information window is where information about the display is located. Usually it shows the horizontal and vertical sync. frequencies. Stephen ----- Original Message ----- From: "stephen senn" <ssenn12@xxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Monday, October 29, 2001 3:45 AM Subject: [TechAssist] Re: Nec monitor jc-1735 info service mode > > Robert, > > With most NEC monitors, you can access the service menu by going to the > information window of the OSD, and then press and hold the reset button, > then the two left and right arrow buttons, and then release all three > buttons. The "Invalidate Warning" window should pop up. Hope this helps. > > Stephen > ----- Original Message ----- > From: "Robert Collins" <electroethier@xxxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Sunday, October 28, 2001 8:53 PM > Subject: [TechAssist] Nec monitor jc-1735 info service mode > > > > How can i access the service menu ? Any info will help. > > Thanks > > > > Robert > > > > Help make your TechAssist online repair tips > > database better! Submit your fixes here: > > http://www.circuitwork.com/techassist/tip/#tips > > To unsubscribe write to: > > techassist-request@xxxxxxxxxxxxx > > with unsubscribe in the subject line. > > > _________________________________________________________ > Do You Yahoo!? > Get your free @yahoo.com address at http://mail.yahoo.com > > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. _________________________________________________________ Do You Yahoo!? Get your free @yahoo.com address at http://mail.yahoo.com Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.