Heat/Chill to re-create the symptom. Check Filter Caps(ESR) on 27v source to Vertical Output Peggs At 06:36 AM 5/13/03, AlHelmetag@xxxxxxx wrote: >Mitsubishi model CK3526R, picture has black bar at top of screen with white >lines about an inch below. There are some foldover of images at the top. >After about 5 minutes the picture slowly inches up to fill in the entire >screen and looks normal. >Replaced caps around the vertical circuit and ic as a last ditch effort to >correct problem with little improvement. What causes the picture to slowly >improve rather than the opposite occuring? >Appreciate your input on this one. >Thanks Again >Al Helmetag >Alhelmetag@xxxxxxx > > >***************************************************************************** >The Tech Address Book: >http://www.tech-assist.org/secure/tip/contact.html >Add a Repair Tip Here, or Change/Remove your Email Address: >http://www.tech-assist.org/secure/tip/main.html >Lost Password: >http://www.tech-assist.org and select "Lost your Login Info?". >Email Archives: >//www.freelists.org/archives/techassist/ Peggs' Electronics 1519 West 2nd Street Owensboro,KY 42301 270-926-4968 fax 270-686-7399 peggs@xxxxxxxxxxxxx ***************************************************************************** The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.html Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.html Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/