Check the supply cap on the vertical B+. al marquardt ampm@xxxxxxx ----- Original Message ----- From: <AlHelmetag@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, May 13, 2003 9:36 AM Subject: [TechAssist] Mitsubishi Vertical Px Fills in Slow > Mitsubishi model CK3526R, picture has black bar at top of screen with white > lines about an inch below. There are some foldover of images at the top. > After about 5 minutes the picture slowly inches up to fill in the entire > screen and looks normal. > Replaced caps around the vertical circuit and ic as a last ditch effort to > correct problem with little improvement. What causes the picture to slowly > improve rather than the opposite occuring? > Appreciate your input on this one. > Thanks Again > Al Helmetag > Alhelmetag@xxxxxxx > > > **************************************************************************** * > The Tech Address Book: > http://www.tech-assist.org/secure/tip/contact.html > Add a Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.html > Lost Password: > http://www.tech-assist.org and select "Lost your Login Info?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ***************************************************************************** The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.html Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.html Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/