Keith, check R701 680 Ohm on crt board, just had one of those last week, good luck, Larry Eastman American TV & Electronics Crystal River, Fl. 34428 Keith Trumbla wrote: >High voltage and sound ok. Proper vertical pulse going to yoke. All G-2's on >CRT are at 200+ Volts cutoff. >IK pin # 25 reads 1.4 v , pin 26 ABL reads 8 volts(too high). This chassis >is slightly different than drawn on schematic. R550 & R551 at pin 10 of FBT >are jumpers instead of 10k each. Is this why my ABL reads higher ? I have a >blank raster and cranking the G-2 does nothing. Tried IC301 and replaced >shorted C-550 so far >HELP >Keith Trumbla >BEM Electronics Inc. >Suite 212-530 Century St. >WPG. MB. R3H 0Y4 Canada >Ph.(204)775-2875 Fax.(204)774-9192 >SITE UPDATED ! >www.bemelectronics.com >***************************************************************************** >Classifieds! Buy or Sell! >http://sell.tech-assist.org >The Tech Address Book: >http://www.tech-assist.org/secure/tip/contact.htm >Add a Repair Tip Here, or Change/Remove your Email Address: >http://www.tech-assist.org/secure/tip/main.htm >Lost Password: >http://www.tech-assist.org and select "Lost your Login Info?". >Email Archives: >//www.freelists.org/archives/techassist/ > > ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/