High voltage and sound ok. Proper vertical pulse going to yoke. All G-2's on CRT are at 200+ Volts cutoff. IK pin # 25 reads 1.4 v , pin 26 ABL reads 8 volts(too high). This chassis is slightly different than drawn on schematic. R550 & R551 at pin 10 of FBT are jumpers instead of 10k each. Is this why my ABL reads higher ? I have a blank raster and cranking the G-2 does nothing. Tried IC301 and replaced shorted C-550 so far HELP Keith Trumbla BEM Electronics Inc. Suite 212-530 Century St. WPG. MB. R3H 0Y4 Canada Ph.(204)775-2875 Fax.(204)774-9192 SITE UPDATED ! www.bemelectronics.com ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/