Ed For test purposes you can put in a sd1886 or 7, note do not try using higher resolution than 640x480 because the switching time on 1886 is a bit too slow. Sounds like a mits set I have on the back of my bench, when cold clicks on and off after a few tries it come on and works forever. Al G teltek3 wrote: > > Repaired this Monitor, Horizontal O/P was shorted. Replaced KSC5088 which > subs to a NTE2324. Seem to run well, but when turning it on "cold" in the > morning, will click about 15 times, about once per second before we finally > get the raster. Anybody run across this Monitor previously, that has any > tips. I think it's a German made Monitor. > Customer did not want it repaired unles it was less than $50, so I inherited > it. ;-) > > TIA > > -Ed- > Tel-Tek Electronics > Ontario-Canada > teltek3@xxxxxxxxxxxx > > ***************************************************************************** > Classifieds! Buy or Sell! > http://sell.tech-assist.org > The Tech Address Book: > http://www.tech-assist.org/secure/tip/contact.htm > Add a Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.htm > Lost Password: > http://www.tech-assist.org and select "Lost your Login Info?". > Email Archives: > //www.freelists.org/archives/techassist/ ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/